iPhone Farm Settings
Just Read the Instructions
Supports all models of iPhone 6s and above IOS system 13.4 and above
For Usage Notes
Note the correct orientation of the default USB small board. If you insert the small board incorrectly and cause a short - circuit burnout, you will bear the risk yourself.
Do not allow any cable ends or metal parts to come into contact with the yellow PCBA area, as this may cause a short circuit in the components and damage to the chassis.
1.Connect iPhone to control panel
Connect the USB C cable to the "电脑" port on the right side of the control board.
2.iPhone Setting
1.Enable Assistivetouch
Settings-Accessibility-Touch-Assistivetouch(ON)-(AlwaysShowMenu-close Tracking Sensitivity -Max)
2.Enable Keyboards
Settings-Accessibility-Keyboards-Full Keyboard Access(On)-Auto Hide(1s)
3.Enable Trackpad&Mouse
Settings-General-Trackpad&Mouse-Tracking SPeed -Max
This option will only appear if the phone, hardware, and computer are connected.
4.Display&Brightness
Settings-Display&Brightness-Brightness(Lowest)-Auto-Lock(Never)-View(Standard)
5.Lock screen orientation
Pop up the control center, open the horizontal and vertical lock, and light up the icon. And close StanBy
6.Double icon
Layout of the control center is based on the hierarchical layout of the corresponding model in the figure below.
The core is that there must be "two rows of icons" at the bottom. It doesn't matter what function icons they are. Settings-->Control Center (+ and - will do), (note that this setting affects automatic screencasting)
7.Screen Mirroring “iMouseXP-***”
Then select Mirror from the Control Center.
The phone must be on the same network as the computer. After mirroring, the phone screen will appear on the computer.
(If it does not appear, then please check the network.)
8.Video demonstration
3.Computer software settings
1.PC and iphone must be same network
Make sure that the mobile phone and computer are on the same network segment. If the system is brand new, please install the VC runtime library.exe first
2.Installation environment
If the computer is equipped with other anti-virus software such as 360 or Windows Security. If so, be sure to trust (iMouse Console Professional Edition) or exit. Otherwise the software will not work properly. Recommended to uninstall
3.Video demonstration
4.Bind hardware
1.After completing screen mirroring-Open the computer software- select phone Right click-Bind hardware-Select the device ID, for example"820A*** | 920B*** | 1020A*** |1120A*** etc...
2.There will be a prompt in the (Log window)system log about Device ID associated with the iPhone.
3.Then select the phone-right-click-Bind hardware The corresponding device ID
5.Mouse sensitivity detection-settings
1.Select the phone with successful screen mirroring-->right-click the mouse-->set mouse parameters
Check your iOS version to make your choice
Please select "1" for IOS version 14.2 or above
If the IOS version is less than or equal to 14.2, please select "2"
2.If the mouse pointer is offset, click the icon to fix it.(Or Check the steps in phone settings.)
4.Internet settings via SIM Card
To access the internet using cellular data, please refer to the following steps.
Open Settings -> Wi-Fi -> Connected Wi-Fi -> Edit
IPv4 address -> Click Edit and select Manual Mode
Enter the IP address and subnet mask. Do not enter the router/gateway field! Do not enter the router/gateway field!
Save and the changes will take effect immediately without affecting screen mirroring. If using a wired connection, the entry point is Settings -> Ethernet.
Last updated